2
61212008L1-5C, Issue 3
61212008L1-5C
source, if one is used. A grounding lug is provided
for frame ground connections.
The rear panel of the T200 Dual Slot Housing
contains two slots with RJ-48S jacks for CPE
connections and a portal for network and power
connections, illustrated in
Figure 3
.
The T200 Dual Slot Housing is 2 inches high by 6
inches wide by 9
3
/
4
inches deep, and weighs less
than 1␣ pound. It can be mounted on a desk, table, or
wall. The unit operating temperature range is -40
°
C
to +70
°
C.
3. INSTALLATION
After unpacking the unit, immediately inspect it for
possible shipping damage. If damage is discovered,
file a claim immediately with the carrier, then
contact ADTRAN Customer Service. (Refer to
subsection 7, Warranty and Customer Service.)
Components shipped with the unit include the
following:
•
T200 chassis (including RJ-48S jack)
•
Four #8 screws
•
Wall mounting template
The T200 chassis is designed to be wall- or
desk-mounted. For wall mounting, four #8 screws
have been included. Select a suitable position on a
wall or desk for installation.
Figure 4
illustrates the mounting pattern in the base
of the chassis. The four mounting screws should be
located as shown. Drive the screws into the
mounting surface, leaving a clearance of at least
1
/
4
␣ inch, and no greater than
1
/
2
inch.
A mounting template is provided with each unit to
assist in locating the drill holes. The template
attaches to the wall by a tape strip located across the
top of the template. Remove the template from the
wall after using.
Grounding Instructions (UL 1950)
In accordance with UL 1950, a supplemental earth
ground must be connected prior to connection of the
telecommunication wiring. The supplemental earth
ground connection shall be connected to the ground
lug.
Grounding instruction information from the
Underwriter’s Laboratory UL 1950 Standard for
Figure 3. T200 housing Rear Panel
CUSTOMER
CIRCUIT 1
CUSTOMER
CIRCUIT 2
NETWORK
R1 LOOP 1
TX T
TX R
RX T1
RX R1
K1
K2
TX T
TX R
RX T1
RX R1
-48V
GND
T1 LOOP 1
R LOOP 2
T LOOP 2
P1
Q1
R1 LOOP 1
T1 LOOP 1
R LOOP 2
R1
D2
R2
TS2
TS4
R3
T LOOP 2
CIRCUIT
2
CIRCUIT
1
CUST
OMER
CIRCUIT
1
CIRCUIT
2
D1
J2
20
19
Ckt 1
Ckt 2
Figure 2. T200 Housing Terminal Barrier Block
