job
Aid
D
ESCRIPTION
The Small Form-Factor Pluggable (SFP) Gigabit Ethernet, Single-
Fiber is a bidirectional SFP that installs into the Optical Loop
Termination (OLT) designed to accept SFPs. The SFP provides a
single optical interface to the GigE physical interface. Installed
into an appropriate OLT, the SFP provides a Gigabit Ethernet
interface to the supporting system.
NOTE
To ensure compatibility, refer to the documentation provided
with the host module.
NOTICE
In a deployment consisting of an OLT with a 1442110G1 SFP
installed; the Optical Network Unit (ONU) should have a comple-
mentary 1442110G2 SFP installed.
F
EATURES
The following features are supported on the SFP:
1000Base-LX 1490 nm Transmitter
1000Base-LX 1310 nm Receiver
Optical distance: 10 km maximum
CAUTION
!
Due to compliance certification requirements, only XFPs supplied
by ADTRAN are to be used with the host module. ADTRAN
cannot certify system integrity with other XFPs.
OLT
1442110G1
1442110G2
ONU
Rx: 1310 nm
Tx: 1490 nm
Rx: 1490 nm
Tx: 1310 nm
Small Form-Factor Pluggable
1490 nm TX/ 1310 nm RX, 10km
I
NSTALLATION
Before installation, inspect the SFP. If damage has occurred
during shipping, file a claim with the carrier, and then contact
ADTRAN Customer Support. For more information, refer to
“Warranty”.
Installation Guidelines
The following are guidelines for this installation.
The latch on the SFP is for removal only. When removing the
SFP, rotate the latch away from the SFP. The SFP should slide
easily out of the cage.
It is recommended that the connector plug remain on
whenever the transceiver optical fiber connector is not
inserted.
Installation Steps
To install the SFP, complete the following steps:
1. Insert the SFP into the SFP cage on the circuit board of the
host module with the latch handle facing outward. Slide the
SFP all the way into the cage.
2. Exert adequate pressure to ensure the SFP is completely
seated in the SFP cage.
3. Do not remove the connector plug until the optical fiber
connection is made.
4. Continue the installation and turn-up of the host module.
S
PECIFICATIONS
Optical Specifications:
o
Transmit wavelength: 1490 nm
o
Receive wavelength: 1310 nm
o
Optical transmit level: –9 dBm to –3 dBm
o
Optical receive level: –19.5 dBm to –3 dBm
o
Optical distance: 10 km
o
Optical connectors: LC
Extended Environmental Support:
o
Operational temperature range: –40°C to +85°C
o
Storage temperature range: –40°C to +85°C
o
Relative humidity to 95%, noncondensing
CLEI: BVL3ADJD_ _
Product P/N: 1442110G1
Issue Date: June 2014
Document P/N: 61442110G1-22B
Documentation for ADTRAN Carrier Networks products is available for
viewing and download directly from the ADTRAN Support Community
website.
Go to:
https://supportforums.adtran.com/welcome
Registration is required.
ADTRAN offers training courses on our products, including customized
training and courses taught at our facilities or at customer sites.
For inquiries, go to:
http://adtran.com/training
The following documents provide additional information for this product:
SFP/XFP/SFP+ Compatibility Matrix and Engineering Guide
