ADTRAN 1702594G1 NetVanta 1234, Руководство по установке оборудования

Страница: 25 / 30

NetVanta 1230 Series Hardware Installation Guide Unit Installation
61702594G1-34C Copyright © 2013 ADTRAN, Inc. 25
Tabletop Installation of the NetVanta
Install the NetVanta on a sturdy, level tabletop or shelf that can support at least 9.35 lbs (4.24 kg). Allow enough
space for ventilation between the NetVanta and other objects in the vicinity.
Wall Mounting the NetVanta
By following these instructions exactly, the NetVanta can be safely mounted to the wall.
Make sure there is adequate ventilation around the NetVanta unit to properly dissipate
heat. Leave at least 4 inches (10 cm) of space at the front and rear of the NetVanta for
ventilation.
• To avoid damaging the unit, use only the screws included in the shipment when
attaching mounting ears to the chassis.
• When wall mounting the NetVanta, care must be taken not to damage the power cord.
Do not attach the power cord to the building surface or run it through walls, ceilings,
floors, or openings in the building structure.
• The socket-outlet must be installed near the equipment and must be easily accessible.
Instructions for Wall Mounting the NetVanta
Step Action
1 Remove the mounting brackets. For a non-PoE 1234 installation, rotate them 90 degrees and
reattach the mounting brackets to the chassis as shown in
Figure 9 on page 26 . For all other
products, attach the specially designed wallmount brackets (P/N 1700506G1) as shown in
Figure 9 on page 26 .
Note: The NetVanta 1234 non-PoE brackets have two slots rather than a single keyhole to
mount to the wall.
2 Decide on a location for the NetVanta. The NetVanta 1230 Series is mounted with the front
panel facing down as shown in
Figure 9 on page 26 . Keep in mind that the unit needs to be
mounted at or above eye level so that the LEDs are viewable.
3 Prepare the mounting surface by attaching a board (typically plywood, 3/4-inch to 1-inch thick)
to a wall stud using #6 to #10 (2.5-inch or greater in length) wood screws.
Important! Mounting to a stud ensures stability. Using sheetrock anchors may not provide
sufficient long-term stability.
4 Have an assistant hold the unit in position as you install two #6 to #10 (1 inch or greater in
length) wood screws through the unit’s brackets and into the mounted board (see
Figure 9 on
page 26 ).
5 Proceed to the steps given in Supplying Power to the Unit on page 26 .