ADTRAN 1700405G1, Руководство по установке оборудования

Страница: 22 / 30

Unit Installation NetVanta 100 Series Hardware Installation Guide
22 Copyright © 2010 ADTRAN, Inc. 61700412E1-34C
Wall Mounting
The NetVanta 150 can be safely mounted on the wall by following these steps:
Figure 3. Wall Mounting the NetVanta 150
Instructions for Wall Mounting
Step Action
1 Install the antennas on the WAP. Refer to Installing the Antennas on page 21 .
2 Decide on a location for the unit. Keep in mind that the unit needs to be mounted at or below
eye level so that the LEDs are viewable.
3 Prepare the mounting surface by attaching a board (typically plywood, 3/4-inch to 1-inch thick)
to a wall stud.
Important! Mounting to a stud ensures stability. Using sheetrock anchors may not
provide sufficient long-term stability.
4 Install two #8 PAN-head wood screws (1-inch or greater in length) into the mounted board,
following these guidelines and referring to
Figure 3 :
• Screws should be spaced horizontally, approximately 4 inches apart.
• Screws should be horizontally leveled with each other.
• Leave approximately 1/4 inch of the screws protruding from the board to allow the heads of
the screws to slide into place in the unit’s keyed insets.
5 Slide the keyed insets on the bottom of the unit’s chassis securely onto the screws.
6 Proceed to the steps given in Getting Started on page 24 .
STAT
WAN
DBU
TD