Remove power from the unit.
If the NIM is already in the NetVanta chassis, remove all cables, release the pins at both edges of the NIM
front panel and slide the module out of the chassis.
Carefully align the P1 connector on the NIM with the J1 connector on the DIM.
Using only
fingertip
pressure
so that neither circuit board bends or flexes, ensure that the connectors are firmly seated.
Secure the DIM to the NIM using the screws and standoff posts supplied. See
Slide the NIM with the DIM attached into the NetVanta chassis, continuing with the normal NIM installation
(refer to
Instructions for Installing the NIMs
below).
Unit Installation
NetVanta 3200/3300/3400 Series
70
Copyright © 2019 ADTRAN, Inc.
61200860L1-34AE
Figure 35. Installing DIMs
Instructions for Installing the DIMs
Step
Action
1
2
3
4