Installation
61187715G1-5B
35
Subscriber Connections
Refer
to
and
to
install
subscriber
POTS,
RF
and/or
Ethernet
services.
POTS Connections
To
connect
POTS,
complete
the
following
steps:
1. Route
the
subscriber
wires
through
the
cable
entry
on
the
bottom
of
the
enclosure.
A
tie
wrap
point
is
provided
for
wire
management
(see
).
2. If
using
an
RJ
‐
11
connector
directly,
it
is
recommended
that
the
cable
be
terminated
with
the
RJ
‐
11
plugs
after
the
subscriber
wires
have
been
pulled
through
the
cable
entry.
Each
RJ
‐
11
connector
is
wired
for
a
single
line.
There
are
two
RJ
‐
11
jack
holders
molded
into
the
enclosure.
3. If
using
the
Terminal
Bridges,
loosen
each
screw
and
attach
the
Green
wire
to
the
TIP
terminal,
and
the
Red
wire
to
the
RING
terminal
and
tighten.
Figure 22. POTS and Ethernet Connections
Tie Wrap Point
FXS 0/1
FXS 0/2
Two-screw
Terminal Bridges
Ethernet
Connections
TIP
RING
TIP
RING
FXS 0/1
FXS 0/2
ETH 0/1
ETH 0/2
TELCO ACCESS
ETH 1
ETH 2
TOTAL ACCESS 362R
1187715G1
12V , 1.5A
POWER
NETWORK STATUS
TELEPHONE TROUBLESHOOTING
1. Identify the bad line.
2. Disconnect the plug from the appropriate POTS jack and plug
any working telephone into that jack.
If the telephone works, there is a problem inside the house.
If the telephone does not work, contact your service provider.
3. Remove the telephone and replace the plug into the POTS jack.
4. Close the unit.
CLEI
TEL. NUMBER
POTS 1
POTS 2
POTS 1
POTS 2
RF Video
F-Type
Connector
