Hybrid Standalone NVR User Guide
3.3.7
IP Filter
The IP filter dialog is shown in Figure 3-18. You can add IP in the following list. The list supports a
maximum 64 IP addresses.
Figure 3-18
After you enabled trusted sites function, only the IP listed below can access current NVR. If you
enable blocked sites function, the following listed IP addresses cannot access current NVR.
Enable
Highlight this box to enable the trusted site function and blocked sites function. You cannot see these
two modes if the
Enable
button is grayed out.
Type
You can select trusted site and blacklist from the dropdown list. You can view the IP address on the
following column.
Start Address/End Address
Select one type from the dropdown list, you can input IP address in the start address and end
address. Click
Add IP Address
or
Add IP Section
to add.
•
Newly added IP addresses are enabled by default. Remove the √ before the item to remove it
from the list.
•
The system supports a maximum of 64 items.
•
The system automatically removes space if there is any space before or after the newly
added IP address.
NVR4200 Series User Guide
49
