K14804V1 6/08 Rev. A
6160VPADT
6160VPADT
6160VPADT
6160VPADT
SafePass
TM
Remote Touchpad
with Prox Reader
INSTALLATION and SETUP GUIDE
GENERAL INFORMATION
The 6160VPADT is an addressable remote Voice
Touchpad with a built-in Proximity Reader, designed
for use with ADT control panels. This Touchpad
provides the following features:
•
Backlit Display (programmable as permanent on
some controls)
•
Continuously Backlit Touchpad Keys
•
Programmable Function Keys
•
Built-in Sounder
•
Arm/Disarm via Prox Tag
•
Voice Chime
•
Voice Status
•
Message Center
•
Supervised by control panel (if supported).
Installation Notes
•
The Touchpad can only be used on addressable
systems and cannot be used on Control Panels that
use Keypad Address 31. The Touchpad must be set
for address 00-30. When used with the Safewatch
Pro/Security Manager 3000 control panels, address 16 must
be assigned to the first Touchpad. Additional Touchpads
must be assigned to addresses 17 – 23. (Refer to Setting the
Touchpad Options.)
•
The Prox reader utilizes an additional keypad address,
which must be enabled at the Control Panel (see control
panel installation instructions for allowable keypad
addresses).
•
The partition used for the Touchpad, Prox Reader, and User
Code must be the same.
•
The Prox Tags will only arm and disarm one partition. The
Prox Reader cannot be used to perform global arming
operations.
•
Presenting a Prox Tag is functionally equivalent to entering
a 4 digit user code.
•
Voice Chime should only be enabled when used with control
panels that support the "chime by zone" mode (e.g.,
SAFEWATCH PRO/SECURITY MANAGER 3000). This
mode must be enabled at the control panel. Refer to the
control panel's installation and setup guide for information
on how to program the chime mode.
6160VPADT QUICK SETUP
The following steps can be used to install the 6160VPADT Remote Touchpad and Prox Reader. For more detailed information
regarding installation, programming and operation, refer to Detailed Information and Installation.
When installing wiring between the Touchpad’s terminal block and the terminal block on the Control Panel, connect only the
red and black Aux. Power connections at the Touchpad initially, and follow the step-by-step instructions for addressing the
Touchpad and Prox Reader.
Step Action
1.
Connect red and black wires only to touchpad.
2.
Program the keypad address. (Safewatch Pro 3000 = 16)
3.
Press * to save.
4.
At the “VOICE CHIME” prompt, press *.
5.
At the “ADDITIONAL CON” prompt, enter “0” if this is the Primary Voice Touchpad, or “1” if this is an additional
Voice Touchpad.
6.
Press * to save.
7.
The “Prox Addr? XX” will be displayed. Enter an unused keypad address.
8.
Press * to save.
9.
Power down the panel.
10.
Connect the green and yellow wires.
11.
Power up the panel.
12.
In panel programming, configure the Prox Reader Address that you just programmed as a keypad.
a. If you are using a Vista-128, Vista-50 or like panels, go to device programming and program the Prox Address
as an “Alpha Console.”
b. If you are using a Safewatch Pro 3000, use an address between 17 and 23.
Go to location *190 to *196 and enter the partition in which the Touchpad is being used.
13. Exit
programming.
14.
Enroll the Prox Tag by programming a new “User” code with the four-digit serial number located on the tag’s
packaging.
