ADT Pulse
®
Interactive Solutions iCamera-1000-ADT Indoor Low-Light Camera
Installation Guide
5
Configuring and Installing the iCamera-1000-ADT
The following instructions provide details of configuring and installing the
iCamera-1000-ADT Indoor Low-Light Camera to your ADT Pulse
network.
Initial setup is done only
one
time to configure the
iCamera’s
wireless settings to
the ADT Pulse Gateway.
Figure 3: Initial Setup
1.
Connect the LAN Cable to the iCamera
a.
Connect the LAN Cable to the LAN Port located on the back of the
iCamera
.
b.
Place the other end of the LAN Cable into the LAN Port of the Y-Cable.
2.
Connecting the Y-Cable to the Gateway
c.
Connect the Y-Cable (with Ethernet) into the Device LAN port of the
gateway.
3.
Connecting the Power Source
d.
Connect the Y-Cable power adapter into the power source. Once
connected, plug the power source into an electrical outlet.
IMPORTANT
DO NOT USE ANY POWER ADAPTER OTHER THAN THE
ONE SPECIFIED. DOING SO MAY DAMAGE THE
DEVICE.
NOTE
During start up, the Power LED displays for approximately 10 to 15
seconds. When installation is complete, the Power LED should
remain ON as well as the Network LEDs.
