adt-audio ToolMod Faderbox, Руководство по установке

Страница: 10 / 60

adt-audio

ToolMod Faderbox
modular Summing Mixer
10
®
®
Power Supply
tible with the ToolMix series of summing boxes, the ToolKit channel strip and
the ToolMod Faderbox. The power supply units can be used with any combina-
tion of these devices without any disadvantage, if the capacity of the particular
power supply unit is sufficient.
TM400 Series ToolMod Consoles come with a 5-pin XLR power output connec-
tor for all ToolMod, ToolMix, and ToolKit units. Using the power supply unit of
a ToolMod console with sufficient capacity for these units is also possible.
Power Supply Rating
Type and number of modules and units determine the version of the required
power supply unit. The three standard power supply units for the adt-audio Tool
devices can be used with almost all existing system setups. Which power supply
unit is suited for a particular setup is determined by the current consumption
of the modules and units and, on rare occasions, by the operation level and the
load on the outputs. The current consumption of the modules and other Tool
devices is listed in the technical specifications of the particular device in the ma-
nuals and on the web pages (www.adt-audio.com). The operation level and the
load is only important if the load on a considerable number of outputs is lower
than 2 k Ω while the operation level is close to the headroom of + 30 dBu.
If you are in doubt which power supply is required for a particular setup,
please ask by phone or email.
Power Supply Units
There are three standard power supply units with different capacities:
ToolPwr-M, ToolPwr-S and ToolPwr-E
ToolPwr-M
The ToolPwr-M is a desk-
top unit with a nominal
output current of 1 amps
and a peak output cur-
rent of 1.5 amps. The
ToolPwr-M comes with
a single 5-pin XLR output
connector. The nominal
power is 100 watts.