SAFETY INFORMATION
GENERAL INSTALLATION
WARNING : THIS APPLIANCE MUST BE EARTHED
IMPORTANT
T
he wires in the mains lead are coloured in accordance with the following code:
Green and yellow:
Earth (E)
Blue:
Neutral (N)
Brown:
Live (L)
As the colours of the wires in the mains lead of the apparatus may not correspond with the coloured markings
identifying the terminals in your plug proceed as follows:
The wire which is coloured green and yellow must be connected to the terminal which is marked by the letter E
or by the safty earth symbol or coloured green and yellow.
The wire which is coloured blue must be connected to the terminal which is marked with the letter N or
coloured black.
The wire which is coloured brown must be connected to the terminal which is marked with the letter L or
coloured red.
If a 13 Amp (BS1363) plug or other type of plug is used, a 5 Amp fuse must be fitted either in the plug or at
the distribution board.
1 DO NOT
expose the unit to rain or moisture. If any fluids of foreign objects
should enter the unit, disconnect the power plug immediately.
2 DO NOT
run microphone cables near mains, data, telephone or 100V lines.
3 PROTECT
the unit from heat and allow adequate ventilation. Place away from
direct source of heat, such as heating vents and radiators.
4 AVOID
jointing the microphone cables, when this is unavoidable make sure a
good screen connector is used.
5 ALWAYS
use a balanced or floating low impedance microphone terminating
in balanced input on long microphone runs.
GENERAL DESCRIPTION
ADS 1015 MIXER AMPLIFIER
The 15 watt RMS amplifier can be used on either Mains or DC power.
The amplifier has two unbalanced microphone inputs and two auxiliary inputs
for background music sources.
Amplifier controls are located on the front panel.
SPECIFICATIONS
RMS Output power
15 Watts into 8 ohm at 1 kHz
Constant Voltage output
100V
Constant Impedance output
4 - 16 ohm
Distorsion at rated power
< 1% THD
Frequency responce
100Hz to 13kHz + or - 3db
Tone Control range
Bass + or - 10db
Treble + or - 10db
Microphone Input
Sensitivity / Imp
-48db + or - 2db/600ohm
S/N ratio
> 55db
Auxiliary Input
Sensitivity
-12db + or - 2db
S/N ratio
>55db
Operating Conditions
Mains power supply
240V AC at 50Hz
Mains power supply
12 Volt
Dimensions (HWD)
83 x 320 x 230
Weight
3.46kg
