OPC9000 series
−
Instruction manual v1.2
20
© ads-tec Industrial IT GmbH • Heinrich-Hertz-Str. 1 • 72622 Nürtingen • Germany
2. Press the loosened clamps in, and insert the device into the wall recess from the front.
3. Once the device is in place, the spring tension should cause the clamps to snap over the inner edge
of the wall recess.
4. Also loosen the remaining clamps.
5. Make sure that all clamps are fully in contact with the rear side of the recess.
6. Tighten the clamping screws, turning alternately by uniform increments in a clockwise direction
(max. 4 Nm).
