Linebox
Please read all the
instructions before
you begin.
The XTE-2005 is
designed to replace
the removable
bottom section on
the standard NTE-5
master socket as shown in the illustration
above. If your socket does not have a split de-
sign with a removable section then the socket
is either not the master socket or is part of an
old installation where the XTE-2005 will not fit.
Removal of the front cover
To start, loosen the two screws on the front
of the master socket and carefully remove the
cover. If you already have extensions the wiring
will be attached to the back of the faceplate.
Make a note of the colours of the wires and the
terminal number they are connected to.
Carefully cut the securing cable tie to free the
cable and carefully
remove the wires from
the faceplate. If they
will not come free cut
the wire as close to the
connector as possible.
2 __________
3 __________
4 __________
5 __________
Making the connections
The XTE-2005 has 6 IDC terminals marked
B,A,5,4,3,2. Use an IDC tool to insert (punch)
extension wires into the terminals. To connect
your existing voice extensions connect the
wires to the numbered terminals in the same
order as removed from the original faceplate.
The extensions connected to the numbered
terminals can be used for voice only as the
ADSL signal has been filtered out.
If you would like to extend the unfilterd
ADSL signal use the terminals labelled B & A.
Standard wiring colours and number to letter
conversion information is shown in the chart
overleaf.
