IMPORTANT - Read entire document and watch all associated videos before installing the ECHO
ECHO!
1. INITIAL SETUP
IMPORTANT!
Complete A-C before proceding with Configuration and Activation.
A. Activate the pre-installed ADS SIM card. The
ECHO
relies on cellular communication to operate, so activate the
SIM card first. Follow the directions in the Initial Set Up section of the
ECHO
ECHO/
Quick Reference Guide
.
B. Download the ADS
Q
start
XML
software,
, and the Bluetooth driver from the software
downloads page.
C. Install ADS
Q
start
XML
software and Bluetooth driver onto the field computer.
Q
start
XML
must be installed prior to
proceeding with steps 2-6. The recommended approach for activating the
ECHO
is using the Bluetooth dongle.
Steps for installing the Bluetooth driver and
Q
start
XML
software are in the Initial Set Up section of the ADS
2. CONFIGURATION AND ACTIVATION
3. ECHO MONITOR INSTALLATION
CHECKLIST!
Parts and tools required on-site for installation:
F
ECHO
monitor
F
Blue magnet
F
Antenna
4. ANTENNA INSTALLATION
Refer to the
ECHO
Quick Installation Guide
for in-manhole installation.
“How to install an antenna for use with ADS Monitors”
for a
walkthrough of outside the manhole antenna installation.
For in-depth installation instructions, refer to the
5. FINAL CONFIGURATION
You are almost there!
– Once the
ECHO
is installed in manhole, there are a few Final Configuration steps to
complete the installation. Follow the steps are outlined in the
Final Configuration and Verification
section of the
ADS ECHO
ECHO/
Q
start
XML
Quick Reference Guide
.
6. VERIFICATION AND STATUS CHECK
It is recommended that wireless communication be verified upon installation of the monitor. Once the
ECHO
is
confirmed to be properly communicating with your network, you can start using
ECHO
in remote monitoring.
F
Mounting bar or wall mount
F
J-hook
F
rubber splicing tape
Watch the ADS video “
How to Configure and Activate an ADS
start
XML
”
before beginning Configuration and Activation. It provides detailed steps to
correctly configure and activate an
ECHO
monitor.
section about Configuration
and Activation. It details how to Create and Configure the Monitor Location and
Activate the Monitor in
Q
start
XML
.
Read Steps 1-6 for Correct Setup, Installation, and Verification
Watch the ADS video
It walks you
through the equipment needed and the process to install the
ECHO
in the field.
Read the
ECHO
Quick Installation Guide.
It is packaged with each
ECHO
monitor. Ensure you have this on-site during field installation to provide easy
step-by-step instructions.
For Further Assistance
Email
or Call
1-877-237-9585
www.adsenv.com/echo
© 2020 ADS LLC. All Rights Reserved.
QR 775036 A0
F
Carpenter’s rule or tape measure
F
Grade pole
F
ECHO
Quick Installation Guide
(included in box)
