7.5.6 PLUMBING REMOVAL
(See Figure 7.5)
Most repairs on fresh water plumbing can be done without removing the plumbing assembly from
the machine. However, when a valve or a strainer body must be replaced the plumbing must be
completely disassembled and removed. The following procedure applies:
1. Remove 45° elbow, washer and gasket from inside the machine sump (4).
2. Rotate the pipe attached to the discharge at the vacuum breaker 90° to an upward direction
as shown.
3. Using a pipe wrench rotate the vacuum breaker inlet pipe and remove this portion of the
plumbing from the machine.
4. Remove the elbow (5).
5. Remove lock nut (6) on plumbing inlet.
6. Remove screw which attaches the gusset to the front sump panel.
7. Remove lower plumbing assembly from the machine.
8. Replace individual parts as required and reassemble in reverse order using teflon pipe
fitting tape on all joints.
Total Restaurant Supply - https://totalsupply1.com - Toll Free 1-800-944-9304 - Local 507-288-9454
2940 Hwy 14 W, Rochester, MN 55901
