PRIOR TO INSTALLATION
IMPORTANT!
ENSURE ALL TILES EXTEND BEHIND AND BENEATH THE BATHROOM FURNITURE.
ADP do not recommend tiling in furniture due to moisture and mould build up which can
damage the material and void the warranty.
ALL AREAS WHERE CABINET MEETS WALL AND/OR FLOOR MUST BE SEALED USING
A NEUTRAL CURE SILICONE.
All edges where vanity top meets cabinet, wall or surrounding furniture must also be
sealed with a continuous bead of silicone.
We recommend that a qualified trades person install this product and we would expect
the installation to be undertaken in a trades person like manner and finished to a trades
person standard. This product carries a full warranty against faulty workmanship and
materials. Please inspect thoroughly before installation to ensure that the product has
not been damaged. It is the responsibility of the installer to make any adjustments to
doors/drawers after installation if required.
Check products for any damages
Positioning & Ventilation
Check for Support Beams
Check for Plumb Walls & Level Floors
Check plumbing positions align with product interior configurations.
Within 48 hours of receiving your goods, unpack your ADP
product and check for any damages or missing parts.
No claims for damages will be recognised after installation.
Check Step 1 on installation guide for parts list. If any
parts are missing, please contact your place of purchase.
Please note: screws/bolts are not supplied.
Furniture must be at least 300mm away from any wet
areas. Materials used in the construction of our units are
moisture resistant, not water proof.
Do not expose furniture to shower spray.
It is important that your bathroom is adequatley
ventilated to eliminate moisture build up.
High humidity will lead to permanent dampness and
mould resulting in a deterioration of the materials in your
bathroom.
Wall hung furniture and wall hung ceramic basins require
fixing to a support beam fitted between the studs to
give a solid wall backing to attach the vanity. If neces-
sary fix additional support noggins at desired height for
cabinet and basin fixing. Ensure total width of support
noggin exceeds vanity width.
Refer to Step 2 for recommended height for your
type of vanity.
1
2
3
4
5
Ensure the Wall is plumb and straight, ensure floor is level. If
you fix the product to a non-plumb wall or floor the following
could happen:
•
Your door or drawers will not operate correctly
•
Door or drawer adjustments will not align.
•
Basins will not sit level, which may cause water to pool
or not drain properly
If it is not possible to make the wall or floor plumb and
straight you must pack the vanity out so that it does not
follow the out of aligned wall.
Floor standing vanities must sit on a level floor or be packed
so they sit level and true.
Please note
if your vanity is fixed to a bowed wall, the
fastening of the fixings will force your cabinet into a twist
and benchtop materials may crack due to increased stress on
joins and materials.
Please note
if your product has any electrical fittings
please allow for this and talk to your electrician
Take note of clearances behind drawers when
considering water supply fittings inside cabinet.
A - 300mm
(minimum clearance)
A
