LAYOUT (FIG. 4, FIG. 5)
CARPET
Carpet and padding will need to be removed up to the hearth line. See FIG. 4 and FIG. 5 below.
Begin the layout by drawing a center line at 45 degrees for a corner installation, or perpendicular to the wall for
a flat‐wall installation. Next, draw the baseline (dimension D ‐ refer to FIG. 4 below and FIG. 5 on page 11) per‐
pendicular to the center line. The base line will be aligned with the front edge of the Firebox Base and the Fire‐
box Pedestal.
CORNER LAYOUT
18” FIREBOX MODELS
MODEL
A
B
C
D
Ornito
2’0”
2’10”
4’1”
2’4”
Santa Fe
2’0”
3’3”
4’6”
2’4”
Frame at
Ceiling
Frame at
Hearth
Hearth
Baseline
24” FIREBOX MODELS
MODEL
A
B
C
D
Orno
2’2”
3’2”
4’6”
2’5”
Santa Fe
2’0”
3’3”
4’7”
2’5”
Frame at
Ceiling
Frame at
Hearth
Hearth
Baseline
Navajo
2’0”
3’9”
4’7”
2’5”
Zuni
2’0”
4’0”
5’4”
2’5”
30” FIREBOX MODELS
MODEL
A
B
C
D
Frame at
Ceiling
Frame at
Hearth
Hearth
Baseline
Orno
2’6”
3’6”
4’10”
2’9”
Santa Fe
2’5”
3’8”
5’0”
2’9”
Navajo
2’5”
4’2”
5’0”
2’9”
Zuni
2’5”
4’2”
5’6”
2’9”
CENTER LINE
BASE LINE
FIG. 4 ‐
CORNER LAYOUT
ELECTRICAL REQUIREMENTS:
ELECTRICAL BOX AND SWITCH
Install an Electrical Box and Wall Switch (or remote control receiver) for fireplace control in the wall at the
desired location. Refer to FIG. 1 on page 9 to locate the minimum distance from the corner that the Switch
should be located. DO NOT CONNECT 110V AC to the wall switch. This wall switch will connect to the low‐
voltage 20AWG of the gas system. 8 Feet of 20 AWG Milli‐volt wire is included prewired to the gas system con‐
trols, which is to be connected to the switch terminals.
WARNING:
LOW VOLTAGE AND 110 VAC VOLTAGE CANNOT SHARE THE SAME ELECTRICAL BOX
This fireplace comes equipped with a 3 volt electronic ignition gas control system. This system includes a two
D‐cell battery pack prewired to the gas system controls, which will provide reliable operation of the system even
in the event of a power outage. Battery polarity must be correct or module damage will occur. An optional 3 volt
AC transformer is available from Adobelite or your dealer for operation using 110V AC. The optional transformer
and the included battery pack CANNOT both be hooked up to the control module at the same time or damage
will occur. Remove batteries from the battery pack before connecting the optional transformer, and unplug the
transformer before installing the batteries.
10
Содержание KIVA 18 Ornito
Страница 2: ...2 This page intentionally left blank...
Страница 4: ...4 This page intentionally left blank...