Admesy MSE Series, Руководство по эксплуатации

Страница: 16 / 25

16
6 Measurement example
The MSE uses default settings when the device is started. These can be
programmed by the end user so that the device starts with the same
settings each time it is connected.
Although it's possible to program all MSE devices individually in a
production environment to start with equal settings, it is recommended to
set the averaging, integration time and SBW values in the initialization
routine of the host software.
A typical measurement example of XYZ would include the following
commands as shown on the right.
Fig 4 Measurement example.
Action may be performed in a loop
Open device (VISA open, RS232 port init)
Set averaging to 1 sample
Set integration time to 16.666ms
Set calibration matrix to the first user
programmable matrix
Set auto-ranging on
Measures CIE X, Y and Z
Read the result back from device
(VISA/USBTMC read command or RS232 read)
open device
close device
:sens:aver 1
:sens:int 16666
:sens:sbw user1
:sens:autorange 1
:meas:xyz
read result
Close the device