14
Hardware Overview
3.2
LPCI-8575 PCI Expansion Card
This section describes the basic function, bus architecture and
jumper settings of the PCI expansion module LPCI-8575.
Functional Block
The LPCI-8575 expansion module is basically a PCI-to-PCI
bridge. The PCI-to-PCI bridge function in the LPCI-8575 supports
legacy address routed traffic, which provides 100% capability with
PCI drivers, application software, BIOS, O/Ss, etc. These func-
tions allow users to transfer their designs without extra effort.
The LPCI-8575 employs a serial interconnect technology,
622Mbps low voltage differential signaling (LVDS). Each LPCI-
8575 expansion module has one link port, the link port is divided
into transmit (TX) and receive (RX). Four TX and RX differential
pairs in the link are used to provide 2.5Gbps full duplex link band-
width or 5Gbps of total bandwidth. Incorporated with the high
speed serial LVDS, it is easy to extend the transmission up to 10
meters through shielded twisted pair copper cables.
Inside the PCI-to-PCI bridge, a PCI-to-StarFabric/StarFabric-to-
PCI converter is used to translate PCI transactions into StarFabric
frames and StarFabric frames into PCI transactions. The PCI inter-
face of the LPCI-8575 is capable of 32-bit/66MHz. Thus the maxi-
mum data throughput can up to 264Mbytes/s. The PCI interface in
LPCI-8575 acts like the primary side of a PCI-to-PCI bridge if
LPCI-8575 is plugged into the peripheral slot.
Figure 3-2: Concept of the serialized PCI bridge
Содержание PCIS-8580-13S
Страница 14: ...6 Introduction ...
Страница 29: ...Hardware Overview 21 Figure 3 5 Bottom view of BP 8005 backplane ...
Страница 36: ...28 Hardware Overview ...