7
HPERC-KBL-M
2
Getting Started
2.1 Preparation
Follow the setup steps in this section in the order listed. Skip any steps that do not apply to
your application.
X
Verify the contents of the shipping box are the same as your HPERC-KBL-M order.
X
If anything is missing or damaged, call your sales representative. Refer to the
chapter for contact information.
2.2 Setting Up the Work Space
2.3 Mounting the Enclosure
Install mounting screws (not included) for surface or wall mounting to the mounting brackets of
the HPERC-KBL-M. Refer to Figure 2-1 and Figure 2-2 for the mounting hole locations of your
model.
Torque Values
NOTE:
NOTE:
To prevent damage to the HPERC-KBL-M, ensure sufficient clearance exists around the
cooling solution for unrestricted airflow.
The air temperature inside the enclosure could rise above the specified operating
temperature limits if the airflow through the cooling solution is restricted.
Select workbench
location.
• The workbench location should be a flat clean surface for setup and
operation (including the connection of any external peripherals and
optional devices).
• Ensure sufficient airflow clearance exists around the complete
enclosure.
Unpack
HPERC-KBL-M.
• Remove the HPERC-KBL-M from its shipping container and place it on
a flat work surface.
• The HPERC-KBL-M enclosure combined with CPU, storage (SSD),
and the desired OS form a complete system, ready for operation.
NOTE:
NOTE:
There are no limitations to the mounting orientation of the device.
Nominal Diameter
Material: Stainless Steel
A2-70 and A4-70
Material: Stainless Steel
A2-80 and A4-80
Material: SCM3 (SCM435)
Strength Grade: 12.9
M6 (HPERC-KBL-MC)
7.6 Nm
11.1 Nm
13.83 Nm
M8 (HPERC-KBL-MH)
18.4 Nm
26.7 Nm
33.34 Nm
