ADLINK Technology DMI-1210, Руководство пользователя

Страница: 36 / 103

24
Leading
EDGE COMPUTING
3.5 Mounting
The DMI-1210 can be panel mounted using 4 countersunk M5
screws and O-rings. Make sure there is adequate space behind
the panel for ventilation and I/O connectors, and that the panel
material and thickness can support the weight of the device.
1. Prepare the panel opening and screw holes as shown in
the Figure 3-1 below (M5 thread or Φ 5.5 through hole).
2. Attach I/O cables to the device before installing into the
panel if rear access will be limited after installation (see
“Mechanical Layout” on page 8.).
3. Place the device into the panel cutout and secure with 4
countersunk M5xL40 screws and O-rings provided as
shown in Figure 3-2 (torque: 10.0 Kgf-cm).
Figure 3-1: DMI-1210 Mounting Hole Locations
CAUTION:
Do not overtighten the screws to prevent damaging the rubber
seal on the back of the bezel.
286
224
274.50
216.90
6.50
2.18
M5 Thread x4
5.5 through hole)
(or