ADLINK Technology cPCI-8586, Руководство пользователя

Страница: 15 / 29

Installation
•
9
3
Installation
This chapter describes the procedures for installing the cPCI-8586 CPU
card into your system.
The following is a list of typical peripherals required to build a minimum
system:
•
Power supply and 3U Compact PCI backplane
•
IBM PC/AT keyboard
•
Display card
•
Display monitor
•
Floppy or hard disk with MS-DOS or Flash Disk emulator
3.1 Installing the SO-DIMMs
You can install from 2MB up to 128MB memory on board using 2,4,8,16,32
or 64MB 144-pin 3.3V FPM/EDO SO-DIMMs.
1. Ensure that all power supplies to the system are switched Off.
2. Insert the first SO-DIMM edge connector at a slight angle into the
socket of DIMM 1 close to the center of the board. Note that the
SO-DIMM is keyed and will only go in one direction.
3. Push the SO-DIMM back into the connector carefully until it snaps
into place.
4. Check to make sure the SO-DIMM is inserted securely.