ADLINK Technology cPCI-6810, Руководство пользователя

Страница: 64 / 82

54 Getting Started
With the cPCI-6810/6820, the CF card is very easy to use; the CF
card socket is available on the cPCI-R6820, which is a rear
transition module.
3.6 PCI Mezzanine Card (PMC) Installation
The PMC slots are designed as 5V and / or as a universal PCI
interface. The PMC sites are keyed to prevent users from
installing a 3.3V only PMC module.
The rear I/O signals on the J14 of the upper PMC slot are routed
to J3 of the 6810/6820 mainboard. Refer to section 2.3 and 2.3 for
detailed PMC I/O signal routing. If a HDD is mounted to the
mainboard, the HDD will occupy the upper PMC slot #1.
Installation of the PMC modules:
1. Prepare an ESD protected area including an anti-ESD
table and ESD strap. Attach the ESD strap to your wrist
and connect the end to the ground of the anti-ESD table.
2. Remove the PMC panel from the front panel.
3. Install the PMC module onto the PMC sockets.
4. Screw the PMC mounting bolts to the main board from
the bottom side up to fix the PMC module in place.
3.7 RTM Installation
This section describes important information regarding the use of
the rear I/O connections. Refer to section 2.4 for peripheral
connectivity of all I/O ports on the RTM. When installing the cPCI-
6820 and its RTM, make sure the RTM is the correct model that
matches its front board.
WARNING: Use the correct RTM to enable functions (I/O
interfaces) on rear side. The RTM or system board
may be damaged if the incorrect RTM is used.