ADLINK Technology CM1-86DX3, Техническое описание

Страница: 34 / 59

28 Interfaces
3.5 Gigabit Ethernet Interface
Table 3-7 describes the pin signals of the Gigabit Ethernet header which consists of 10
right-angle pins, two rows, odd/even (1,2) pin sequence, and 0.079" (2mm) pitch.
Note : The shaded table cells denote ground.
3.6 Gigabit Ethernet External LED Interface
Table 3-8 defines the signals of the external LED that indicates Gigabit Ethernet links and activ-
ity using a single row of 4 pins with 0.049" (1.25mm) pitch.
Note : The shaded table cell denotes power. The * symbol indicates the signal is Active Low.
3.7 Video (TFT/VGA) Interface
Table 3-9 describes the pin signals of the Video interface, which uses a 44-pin, right-angle
header with 2 rows, odd/even sequence (1, 2), and 0.079" (2mm) pitch.
Table 3-7: Gigabit Ethernet Interface Pin Signals (CN9)
Pin # Signal Description
1 ETH-PE Connected through two 75 ohm resistors in series to center tap of
isolation transformer and then to ground through common 1k PF
capacitor.
2 ETH-PE
3 ETH1_TRD0_P Media Dependent Interface 0 +/-
4 ETH1_TRD0_N
5 ETH1_TRD1_P Media Dependent Interface 1 +/-
6 ETH1_TRD1_N
7 ETH1_TRD2_P Media Dependent Interface 2 +/-
8 ETH1_TRD2_N
9 ETH1_TRD3_P Media Dependent Interface 3 +/-
10 ETH1_TRD3_N
Table 3-8: Gigabit Ethernet External LED Pin Signals (CN8)
Pin # Signal Description
1 +V3P3 +3.3 volts Power
2 ETH1_LINK_ACT* Indicates link connectivity or transfer data activity
3 ETH1_LED_100* Indicates link activity at 100 Mbps
4 ETH1_LED_1000* Indicates link activity at 1000 Mbps
Table 3-9: Video Interface Pin Signals (CN7)
Pin # Signal Description
1 FP1_CLK TFT Shift Clock – This clock signal provides the timing for transferring digital
pixel data.
2 FP1_DE TFT Data Enable – This signal indicates valid data on any of the FP [23:0]
lines.
3 FP1_HSYNC TFT Line Pulse – This signal is the digital monitor equivalent of HSYNC.
4 FP1_VSYNC TFT Frame Marker – This signal is the TFT monitor equivalent of VSYNC.
5 GND1 Ground 1
6 GND2 Ground 2
7 NC Not connected (FP0 = Flat Panel Data 0)
8 NC Not connected (FP1 = Flat Panel Data 1)
9 FP2 Flat Panel Data 2 – data output, Blue0 (18-bit)