Press the
Menu
button to display the different functions (see table below for a description of the
functions). Use the
Up
or
Down
arrow buttons to make your selection. When you have chosen
your desired function, press the
Enter
button to confirm the change.
Auto modes: AT01 – AT09
can be adjusted by Speed S_01 – S_32
Sound to Light modes: So01 – So09
can be adjusted by Sensitivity Sn01 – Sn09
Display
Mode
d001 -512
DMX Control
chnd
DMX Channels
3CH
3 channel DMX mode
6CH
6 channel DMX mode
AT01 – AT09
Auto Built-in Programs
S_01 – S_32
Speed
So01 – So03
Sound
Sn01 – Sn09
Sound Sensitivity
Slav
Slave Mode
DMX-512 connection
If you are using a standard DMX controller, you can connect the DMX output of the controller
directly to the DMX input of the first unit in a DMX chain. If you wish to connect a DMX controller
with other XLR outputs you will need to use adapter cables.
Connection of Signal Cable
To connect multiple Party Bar X5 systems you can use a 3-pin XLR cable to connect the OUT socket
of the first light to the IN socket of the following light. A DMX signal terminator is recommended on
the OUT socket of the last unit of the chain. A DMX terminator is a
XLR connector with a 120Ω
resistor between the pin 2 and pin 3 of the XLR connector.
DMX output
1 = Shield
DMX
input
2 = Signal (-)
3 = Signal (+)
Connect the DMX output of the first unit in a DMX chain with the DMX input of the next unit in the
chain. Always connect the the output of one unit with the input of the next unit until all units are
connected.
