Page 4
Electrical requirements (cont.)
1.
The wire coloured green and yellow
must be connected to the
terminal in the plug that is marked by the letter E, or by the
safety earth symbol coloured green, or green and yellow.
2.
The wire coloured blue
must be connected to the terminal,
which is marked with the letter N.
3.
The wire coloured brown
must be connected to the terminal,
which is marked with the letter L.
NOTE:
Replacement of the mains cable
must be done by a competent service
engineer.
HEATING ELEMENT
The heating element
fitted to the
Studio Clam Press
is rated at 2200
Watts and the element for the
Studio Mini Clam Press
is rated at 1750
Watts.
Never connect
to any outlet or power supply having a different
voltage/frequency from that on the machine data plate.
2.4
Adjusting the pressure
This press is fitted
with a pressure-adjusting unit, which enables the
heat plate assembly to be raised or lowered by use of a pressure
adjustment knob located on the top of the heat plate:
a)
To increase pressure
or to use thinner materials turn knob
clockwise.
b)
To decrease pressure
or to raise the heat plate assembly to
enable thicker materials to be used, turn the adjustment knob
anticlockwise.
NOTE
DO NOT adjust the pressure when the machine is clamped shut
CAUTION
This machine is designed to be used with a light to medium
clamping pressure. If the pressure of the machine is adjusted too
high this may cause damage to the machine and invalidate your
warranty. Other machines are available for high-pressure
applications. Please ask your supplier for details.
