background image

ADJ Products, LLC  -  www.adj.com  - VF1600 Instruction Manual Page 6

ADJ Products, LLC  -  www.adj.com  - VF1600 Instruction Manual Page 7

  VF1600  

 

 

 

                        Description

The  new  VF1600  fog  machine  included  a  revolutionary  new  heat-

ing element that has been specially designed to prevent excessive 

particle  build  up  that  can  cause  premature  fogger  failure.  This  fog 

machine  has  a  wide-angle  spray  nozzle  and  long-life  pump  that 

was specially designed for high performance fogger output. The fog 

machine  also  includes  a  remote  control,  that  may  be  removed  for 

periods on non-use.

  VF1600  

 

 

 

 

                      Set-Up

1. Open the shipping carton and carefully remove the unit from the  

  shipping carton.
2. Be sure to remove all the packing material especially around the  

  nozzle.
3. Set the fog machine on a flat dry surface. Locate the included    

  bracket from the package and install it using the supplied hard-  

  ware to the side casing. Note: The bracket is an optional accesso- 

  ry and may not be used if desired, however if you intend to sus- 

  pend the unit from truss the bracket must be used.
4. Fill the fog fluid reservoir with American DJ

 

brand fog juice only  

  and then tighten the cap. 
5. Firmly attach the remote control unit to the rear remote control 

  socket on the unit.
6. Plug the unit in to a matching power supply. At this time the fluid  

  reservoir will glow red, this indicates that the unit is heating up.  

  Wait about eight minutes for the fogger to reach normal operating  

  temperature. When it has reached the temperature, the reservoir  

  will glow green.
7. Either press the remote button to emit fog, use the timer function  

  or use the manual button on the rear of the unit to emit fog. See  

  Timer Remote operation on the next page for operating instruc- 

 tions.

  VF1600  

 

                                            DMX Set Up

5-Pin XLR DMX Connectors.

 

Some manufactures use 5-pin DMX-

512 data cables for DATA transmission in place of 3-pin. 5-pin DMX  

fixtures may be implemented in a 3-pin DMX line. When inserting stan-

dard 5-pin data cables in to a 3-pin line a cable adaptor must be used, 

these adaptors are readily available at most electric stores. The chart 

below details a proper cable conversion.

Conductor

5-Pin XLR Male (In)

3-Pin XLR Female (Out)

Pin 1

Pin 5 - Do Not Use

Pin 4 - Do Not Use

Pin 3

Pin 2

Pin 1

Pin 3

Pin 2

Not Used

Not Used

Data True (+ signal)

Data Compliment (- signal)

Ground/Shield

3-Pin XLR to 5-Pin XLR Conversion

DMX Mode:

The VF1600 has 1 DMX channel. Channel 1 is fog output.

1.  This function will allow you to control each individual fixture’s   

  traits with a standard DMX 512 controller.

2. 

To run your fixture in DMX mode set the DMX address using the    

  dipswitches located on the rear panel of the unit.

3.   After you have set your DMX address plug in the fixture via the  

    XLR connections to any standard DMX controller. Follow the set- 

    up specifications that come with your DMX controller.

  VF1600  

 

                                           DMX Control

Отзывы: