ADJ Products, LLC - www.adj.com - Super Spot LED Instruction Manual Page 11
press and hold the MENU button for at least 3 seconds to acti-
vate. After you have set your desired show, it can be changed
at any time using the UP or DOWN buttons.
SOUN
- Sound Active mode.
1. Press the MENU button until “
SOUN
” is displayed, press
ENTER.
2. The display will show either “
ON”
or
“OFF
”. Press the UP or
DOWN buttons to select “
ON
” to activate sound active mode,
or “
OFF
” to deactivate sound active mode.
3. Press ENTER to confirm.
SENS
- In this mode you can adjust the sound sensitiv-
ity.
1. Press the MENU button until “
SENS
” is displayed, press
ENTER.
2. A number between 0-100 will be displayed. Press the UP or
DOWN buttons to adjust the sound sensitivity. 0 being the least
sensitive, and 100 being the most sensitive.
3. When you have found your desired setting press ENTER to
confirm.
DNST
- This mode can be used as a precaution mode,
that in case the DMX signal is lost, interrupted, or power is
lost, the operating mode chosen in the setup is the running
mode the fixture will go into when the DMX signal is lost. You
can also set this as the operating mode you would like the
unit to return to when power is applied.
1. Press the MENU button until “
DNST
” is displayed, and either
“
MASL
”, “
BLND
”, or “
LAST
” will be displayed beneath.
2. Press ENTER and the bottom choice will begin to flash. Use
Super Spot LED
System Menu
ADJ Products, LLC - www.adj.com - Super Spot LED Instruction Manual Page 10
Super Spot LED
System Menu
System Menu: When making adjustments press ENTER to
confirm your setup then press and hold the MENU button
for at least 3 seconds. To exit without making any adjust-
ments press the MENU button. The display will lock after 30
seconds, press the MENU button for 3 seconds to unlock.
ADDR
-
DMX Address Setting
.
1. Press the MENU button until “
ADDR
” is displayed, press
ENTER.
2. The current address will now be displayed and flashing.
Press the UP or DOWN buttons to find your desired address.
Press ENTER to set your desired DMX address.
SLND
- This will let you set unit as a master or slave in a
master/slave configuration.
1. Press the MENU button until “
SLND
” is displayed, press
ENTER. Either “
SL 1
”, “
SL 2
”, or “
MAST
” will be displayed.
2. Press the UP or DOWN buttons until your desired setting is
displayed, press ENTER to confim.
NOTE: In a Master/Slave configuration you can set one fixture
to Master and then set the next fixture to “
SL 2
”, the fixtures
will now have contrast movement to each other.
SHND
- Show modes 0-1 (Factory programs). Show
mode can run with or without sound active mode active.
1. Press the MENU button until “
SHND
” is displayed, press
ENTER.
2. “
Sh X
” will now be displayed, “
X
” representing a number
between 0-1. Shows 1 is a factory program, while show “0” is
random mode. Use the UP or DOWN buttons to find your desired
show.
3. When you have found your desired show press ENTER, then
