PinPoint GO COLOR ADJ LED RC2 Remote
The ADJ LED RC2 infrared remote (Sold Separately) has many dif-
fernet functions and gives you complete control of your PinPoint GO
COLOR. To control the your desired fixture you must aim the control-
ler at the front of the fixture and be no more the 30 feet away.
BLACKOUT
-
Pressing this button will blackout the fixture. This but-
ton is also used to switch between normal mode and energy saving
mode. Press the button for at least five seconds, when the LED’s
flash two times you are in normal mode, when the green LED flashes
you are in energy saving mode.
SELECT PROG (PROGRAM)
-
Press this button scroll through slow
color fade, fast color fade, slow color change, and fast color change.
Press the Speed button and use the +” & “-” buttons to adjust the
program speed. Press the Flash button to activate strobing and use
the +” & “-” buttons to adjust the strobe speed.
MANUAL COLOR MODE
-
Press the R/G/B/A buttons to select one
of the four colors. Use the “+” & “-” buttons to adjust the output inten-
sity of each color. Press the Flash button to activate strobing and use
the +” & “-” buttons to adjust the strobe speed.
COLOR SELECT MODE
-
Press the “1” button to activate color se-
lect mode. Use the “+” & “-” buttons to scroll through the 64 color
macros. Press the Flash button to activate strobing and use the +” &
“-” buttons to adjust the strobe speed.
Mode Operation:
Each press of the MODE button will cycle through the different oper-
ating modes. The operating modes are listed below in the order that
they appear.
NOTE: When power is turned OFF and turned back ON, the unit
will start in the last operating mode.
Order of Operating Modes:
• 64 Color Macros • Fast Fade • Fast Change • Slow Fade • Slow
Change • LED Off
Pressing the MODE button again after LED Off will return the unit to
the first color macro. Starting the operating mode order at the begin-
ning.
PinPoint GO COLOR Operating Instructions
The PinPoint GO COLOR comes with a frost filter. To install the filter
carefully remove the retainer ring in front of the lens. Install the filter
and replace the retainer ring. Make sure the filter cut out for the infrared
receiver is in the correct place.
The unit has two ways that it can be installed. The unit includes
a X-Clip so that it can be installed on drop down ceilings. Always
ensure that the unit is firmly fixed to avoid vibration and slipping while
operating. Always ensure that the structure to which you are attach-
ing the unit is secure and is able to support a weight of 10 times the
unit’s weight. Always use a safety cable that can hold 12 times the
weight of the unit when doing this type of installation. The safety
cable should go through the eye hole nut that holds the X-Clip base in
place.
You can also install using the magantic base. To do this, remove the
X-Clip base by unscrewing the eye hole bolt. Once removed the fix-
ture can be stuck to anything magnetic.
The equipment must be installed by a professional, and it must
be installed in a place where it is out of the reach of people’s
grasp.
PinPoint GO COLOR Frost Filter Install
PinPoint GO COLOR Installation
ADJ Products, LLC - www.adj.com - PinPoint GO COLOR User Manual Page 8
ADJ Products, LLC - www.adj.com - PinPoint GO COLOR User Manual Page 9
PinPoint GO COLOR Photometric Chart