Fog Fury Faze
Description
Fog Fury Faze
Remote Operation
The new Fog Fury Faze fog machine included a revolutionary new
heating element that has been specially designed to prevent exces-
sive particle build up that can cause premature fogger failure. This
fog machine has a wide-angle spray nozzle and long-life pump that
was specially designed for high performance fogger output. The fog
machine also includes a remote control, that may be removed for
periods on non-use.
Always be sure to maintain an adequate supply of American DJ
Fog Juice Brand Fog Juice in the fluid reservoir. Running the fog
machine dry will cause pump failure and or clogging. This is the
largest cause of failure in fog and haze machines. Only American
DJ Fog Juice is recommended and not all fog juice is created
equal.
Remote Operation:
Start by connecting the remote to the fog
machine. Once the machine is plugged in and turned on, a red power
LED on the remote will glow indicating the unit is receiving power.
After the unit has warmed up, a GREEN LED on the remote will light
indicating the unit is ready to emit fog. To emit fog, simply press the
button on the remote for desired length of time. If the GREEN LED is
on and fog does not come out after holding the button down for 30
seconds, check the fluid tank and make sure you have enough fog
juice.
Caution:
Before removing or replacing the remote control unit
disconnect the power supply.
Fog Fury Faze
Set-Up
1. Open the shipping carton and carefully remove the unit from the
shipping carton.
2. Be sure to remove all the packing material especially around the
nozzle.
3. Set the fog machine on a flat dry surface. Locate the included
bracket from the package and install it using the supplied hard-
ware to the side casing. Note: The bracket is an optional accesso-
ry and may not be used if desired, however if you intend to sus-
pend the unit from truss the bracket must be used.
4. Fill the fog fluid reservoir with American DJ
brand fog juice only
and then tighten the cap.
5. Firmly attach the remote control unit to the rear remote control
socket on the unit.
6. Plug the unit in to a matching power supply. At this time the fluid
reservoir will glow red, this indicates that the unit is heating up.
Wait about four minutes for the fogger to reach normal operating
temperature. When it has reached the temperature, the reservoir
will glow green.
7. Press the remote button to emit fog.
8. Follow the operating instructions on the next page for remote
operation.
ADJ Products, LLC - www.adj.com - Fog Fury Faze Instruction Manual Page 4
ADJ Products, LLC - www.adj.com - Fog Fury Faze Instruction Manual Page 5
