ADJ Products, LLC - www.adj.com - Focus Spot Three Z Instruction Manual Page 23
ADJ Products, LLC - www.adj.com - Focus Spot Three Z Instruction Manual Page 22
NOTE: In a Master/Slave configuration you can make one
fixture the Master and then set the next fixture to “Slave 2”, the
fixtures will now have contrast movement to each other.
Show Mode
- Show modes 1 - 4 (Factory Shows).
1. Press the MENU button until “Show Mode” is displayed, press
ENTER.
2. “Show X” will now be displayed, “X” representing a number
between 1-4. Press the UP or DOWN buttons to find your desired
show and press ENTER to confirm. After pressing ENTER, press
and hold the MENU button for at least 3 seconds to activate.
Sound State
- In this mode the unit will run in sound
active mode.
1. Press the MENU button until “Sound State” is displayed, press
ENTER.
2. Either “On” or “Off” will now be displayed. Use the UP or
DOWN buttons to toggle between “On” and “Off”.
3. Press ENTER to confirm your selection, the press and hold the
MENU button to activate.
Sound Sense
- In this mode you can adjust the sound
sensitivity of the sound active mode.
1. Press the MENU button until “Sound Sense” is displayed,
press ENTER.
2. Press the UP or DOWN buttons to adjust the sensitivity level.
The sensitivity level can be adjusted between 0 (the lowest) and
100 (most sensitive).
3. Press ENTER to set you desired level.
DMX Last State
-
This mode can be used as a precau-
tion mode, that in case the DMX signal is lost, the operating
mode chosen in the setup is the running mode the fixture
will go into when the DMX signal is lost. You can also set
this as the operating mode you would like the unit to return
to when power is applied.
1. Press the MENU button until “DMX State” is displayed, press
ENTER.
2. Either “Master/Slave”, “Blackout”, or “Last State” will be dis-
played. Choose an operating mode you would like the unit to
start up in when power is applied or the DMX signal is lost.
• Master/Slave - If the DMX signal is lost or power is applied, the
unit will automatically go into Master Slave mode.
• Blackout - If the DMX signal is lost or power is applied, the unit
will automatically go into stand by mode.
• Last State - If the DMX signal is lost the fixture will stay in the
last DMX set up. If power is applied and this mode is set, the unit
will automatically go into the last DMX set up.
3. Press ENTER to confirm your desired set up.
Dimmer Curve
- In this mode you can select the dimmer
curve.
1. Press the MENU button until “Dimmer Curve” is displayed,
press ENTER.
2. The current dimmer curve setting will be displayed.
3. Press the UP or DOWN buttons to find your desired dimmer
curve and press ENTER to confirm. See the Dimmer Curve Chart
on page 22 for the settings.
Focus Spot Three Z
System Menu
Focus Spot Three Z
System Menu