ADJ Products, LLC - www.adj.com - Flat Par QWH12XS User Manual Page 11
Master-Slave Operation:
This function will allows you to link units together to run in a Master-
Slave configuration. In a Master-Slave configuration one unit will act
as the controlling unit and the others will react and copy the control-
ling units operation. Any unit can act as a Master or as a Slave how-
ever, only one unit can be programmed to act as the “Master.”
Master-Slave Connections and Settings:
1. Daisy chain your units via the XLR connector on the rear of the
unit. Use standard XLR data cables to link your units together.
Remember that the Male XLR connector is the input and the Fe-
male XLR connector is the ouput. The first unit in the chain
(master) will use the female XLR connector only. The last unit in
the chain will use the male XLR connector only.
2. Connect the first “Slave” unit to the “Master.”
3. Set the “Master” unit to your desired mode of operation. The
“Slave” unit will now follow the “Master”.
Flat Par QWH12XS Operating Instructions
With this feature you can connect the fixtures to one another
using the IEC input and output sockets. The quantity that can be
connected is 7 fixtures maximum. After 7 fixtures you will need to
use a new power outlet. They must be the same fixtures. DO NOT
mix fixtures.
Flat Par QWH12XS Power Cord Daisy Chain
ADJ Products, LLC - www.adj.com - Flat Par QWH12XS User Manual Page 10
Flat Par QWH12XS Operating Instructions
To run the 8 Channel Mode, press the MODE button until “Ch.08”
is displayed. This is the 8 Channel DMX Mode.
4. Please see pages 15-20 for DMX values and traits.
5. After you have chosen your desired DMX Channel mode
plug in
the fixture via the XLR connections to any standard DMX controller.
Default Running Mode:
This is a default running mode. When this mode is activated all modes
will return to their default settings.
1. Plug the fixture in and press the MODE button until “dXX” is dis-
played. “XX” represents either “on” or “oFF”.
2. Press the SET UP button until “dEFA” is displayed.
3. Press the UP and DOWN buttons simultaneously. Press the MODE
button to exit.
Infrared Receiver:
This function is used to activate and deactivate the infrared receiver.
When this function is activated you can control the fixture using the ADJ
LED RC 2 (Remote Control). Please see the next page for ADJ LED RC 2
controls and functions.
1. Plug the fixture in and press the MODE button until “dXX” is displayed.
“XX” represents either “on” or “oFF”.
2. Press the SET UP button until “IrXX” is displayed. “XX” represents
either “on” or “oF”.
3. Press the UP or DOWN buttons to either activate the remote func-
tion (On) or deactivate it (Off).
