ADJ ENCORE BURST, Руководство пользователя

Страница: 19 / 26

SYSTEM MENU
DMX ADDRESS - Use this menu to set your desired DMX address.
DMX CH MODE - In this menu you can find and set your desired DMX channel mode.
NO DMX STATUS - Use this menu to control how your device will behave in the event that DMX
signal is lost or interrupted. Available options are shown below:
• Hold Last - This setting will have the fixture stay in the last DMX setup.
• Blackout - This setting will have the fixture automatically go into stand by mode.
• Manual - This setting will go into the current manual control set up. See the Manual Control
section below for details.
DIM MODES - In this menu you are able to select your desired dimmer mode and adjust the dim-
ming speed time.
LED REFRESH RATE - In this menu you are able to select your desired LED refresh rate.
GAMMA - In this menu you are able to select your desired gamma setting.
DISPLAY - In this menu you you are able to activate/deactivate the backlighting and the display lock
feature.
SERVICE - In this menu you are able to access and adjust/change: the calibration (effect adjust) and
restore the factory settings.
MANUAL CONTROL - This menu is for manual testing and manual control. The color, dimmer,
strobe, and program parameters can be tested/adjusted. The fixture must be set to “Manual” under
“No DMX State”.
INFORMATION - FIXTURE LIFE TIME
• Power On Time -The TOTAL power ON running time of the unit is displayed. This time CANNOT
be reset.
• P-On Time-R - The CURRENT power ON running time of the unit is displayed. This running time
may not be the same as the TOTAL power ON running time displayed under “Power On Time”.
This time CAN be reset. NOTE: The displayed time represents the current power ON time since
the last reset.
• P-On Time-Reset - Reset the CURRENT power ON running time that is displayed under “P-On
Time-R”.
INFORMATION - TOTAL LED TIME
• LED On Time - The TOTAL LED ON time is displayed. This total LED ON time CANNOT be reset.
NOTE: The displayed time represents the TOTAL LED ON time.
• LED On Time-R - The CURRENT LED ON running time is displayed. This running time may not
be the same as the total LED ON time displayed under “LED On Time”. This total LED ON time
CAN be reset. NOTE: The displayed time represents the current LED ON time since the last reset.
• LED On Time Reset - With this function you can reset the CURRENT LED ON time that is dis-
played under “LED On Time-R”.
ADJ Products, LLC - www.adj.com - Encore Burst RGBW IP User Manual Page 19