10
OPERATING INSTRUCTIONS
LED Display On/Off:
To set the LED display to turn off after 10 seconds of inactivity, press the MODE button until “dS-x”
is displayed. “X” represents either “1” or “2”. Press the UP or DOWN buttons so that “dS-2” is dis-
played. Now the display will disappear after 10s. Press any button to turn the display on again.
• “dS-1” = LED display on at all times.
• “dS-2” = LED display shuts off after 10 seconds of inactivity.
DMX Mode:
Operating through a DMX controller gives the user the freedom to create their own programs tailored
to their own individual needs. The Eco UV Bar DMX has 3 DMX Channels.
• This function will allow you to control the fixture’s traits with a standard DMX 512 controller.
• To run your fixture in DMX mode press the MODE button until “1XXX” is displayed. “XXX” rep-
resents the currently selected address. Use the UP and DOWN buttons to select your desired
DMX address.
• Please see the DMX Traits section of this manual for detailed information.
• After you have set your desired DMX address, connect the fixture to any standard DMX controller
using the device’s XLR connections.
Strobe Mode:
1. Plug the fixture in and press the MODE button until “2-XX” is displayed. “XX” represents a num-
ber between 1-20.
2. The strobe speed can be adjusted between 1 (slowest) to 20 (fastest).
3. Use the UP and DOWN buttons to adjust the speed as desired.
Output Intensity:
1. Plug the fixture in and press the MODE button until “UXXX” is displayed. “XXX” represents a
number between 000-255.
2. The output intensity can be adjusted between 000 (off) to 255 (brightest).
3. Use the UP and DOWN buttons to adjust the output intensity as desired.
UV Fade Mode:
1. Plug the fixture in and press the MODE button until “AFXX” is displayed. “XX” represents a num-
ber between 1-3.
2. The fade speed can be adjusted between 1 (slowest) to 3 (fastest).
3. Use the UP and DOWN buttons to adjust the fade speed as desired.
Delay:
1. Plug the fixture in and press the MODE button until “dr-X” is displayed. “X” represents a number
between 0-4 (0 = No Delay, 1 = Standard, 2 = Stage, 3 = Architectural, 4 = Stage 2).
2. Use the UP and DOWN buttons to adjust the delay as desired.
Note: The delay mode works in conjunction with Channel 3 values 101-255
