ADJ Products, LLC - www.adj.com - 3D Vision Encoder Instruction Manual Page 3
3D Vision Encoder
General Instructions
3D Vision Encoder
Precautions
• Do not attempt to remove or break off the ground prong from the
electrical cord. This prong is used to reduce the risk of electrical
shock and fire in case of an internal short.
• Do not remove the unit cover under any conditions. There are no
user serviceable parts inside.
• Never plug this unit in to a dimmer pack
• Always be sure to mount this unit in an area that will allow proper
ventilation. Allow about 6” (15cm) between this device and a wall.
• To reduce the risk of electrical shock or fire, do not expose this unit
rain or moisture.
• This unit is intended for indoor use only, use of this product out-
doors voids all warranties.
• During long periods of non use, disconnect the unit’s main power.
• Always mount this unit in safe and stable matter.
• Power-Cord Protection - Power-supply cords should be routed so
that they are not likely to be walked on or pinched by items placed
upon or against them, paying particular attention to cords at plugs,
convenience receptacles, and the point where they exit from the
fixture.
• Cleaning -The fixture should be cleaned only as recommended by
the manufacturer.
• The fixture should be serviced by qualified service personnel
when:
A. The power cord or the plug has been damaged.
B. Objects have fallen, or liquid has been spilled into the appliance.
C. The appliance has been exposed to rain or water.
D. The fixture does not appear to operate normally or exhibits a
marked change in performance.
To optimize the performance of this product, please read these
operating instructions carefully to familiarize yourself with the
basic operations of this unit. These instructions contain impor-
tant safety information regarding the use and maintenance of this
unit. Please keep this manual with the unit, for future reference.
3D Vision Encoder Introduction
Introduction: Congratulations and thank you for purchasing the
ADJ 3D Vision Encoder. The 3D Vision Encoder is an essential
piece used to set the DMX address of the 3D Visions.
Customer Support: ADJ Products, LLC provides a toll free cus-
tomer support line, to provide set up help and to answer any
question should you encounter problems during your set up or
initial operation. You may also visit us on the web at www.adj.
com for any comments or suggestions. For service related issue
please contact ADJ Products, LLC. Service Hours are Monday
through Friday 8:00 a.m. to 4:30 p.m. Pacific Standard Time.
Voice:
(800) 322-6337
Fax:
(323) 725-6100
E-mail:
Warning! To prevent or reduce the risk of electrical shock or fire,
do not expose this unit to rain or moisture.
Caution! There are no user serviceable parts inside this unit. Do
not attempt any repairs yourself, doing so will void your manu-
factures warranty. In the unlikely event your unit may require ser-
vice please contact ADJ Products, LLC.
PLEASE recycle the shipping carton whenever possible.
ADJ Products, LLC - www.adj.com - 3D Vision Encoder Instruction Manual Page 2
