ADJ 1215200019, Инструкция пользователя

Страница: 21 / 28

ADJ Products, LLC - www.adj.com - Jolt 300 User Manual Page 20
Jolt 300 System Menu
DMX MODE - The submenus listed under DMX MODE are as follows: ADDR (Address), CHAN
(Channel Mode), and NO (No DMX Status).
- ADDR - In this submenu you are able to find and set your desired DMX address.
- CHAN - In this submenu you are able to find and set your desired DMX channel mode.
- NO - This setting is used as a precaution mode in case the DMX signal is lost or interrupted. The
operating mode chosen is the running mode the fixture will go into when the DMX signal is lost.
Listed below are the 3 modes.
• HOLD - This setting will have the fixture stay in the last DMX setup.
• BLACK - This setting will have the fixture automatically go into blackout mode.
• PROG - This setting will have the fixture run an internal program.
PERSONALITY - The submenus listed under PERSONALITY are as follows: Master, Slave, IR, Dim
Mode, LED Refresh Rate, GMA (Gamma), BACK (BACKLIGHT), USB, SOFT (SOFTWARE UPDATE),
and REST (RESET).
- MAST - Set the unit to act as the Master unit in a master-slave set up.
- SLAV - Set the unit to act as the slave unit in a master-slave set up.
- IR - In this submenu you can activate the IR sensor for use with IR remote.
- STANDARD, STAGE, TV, ARCHI, THEATRE, STAGE 2 - In this submenu you are able to set your
desired dimmer mode or dimming speed. See the dimmer curve chart on page 23 for more information.
- 1200, 900-1500, 2500, 4000-6000, 10000, 15000, 20000, 25000HZ) - In this submenu you are able
to set your desired LED refresh rate.
- GMA - In this submenu you are able to set your desired gamma brightness.
- BACK - In this submenu you are able to adjust the display blackout time.
- LOCK - In this submenu you are able to adjust the display lock time.
- USB - In this submenu you are able to power the USB port on/off.
- SOFT - In this submenu you are able to update the unit to the latest software version.
- REST - In this submenu you are able to reset the unit to its factory (default) settings.
MANUAL - This submenu is for manual control and testing.