Sidewinder X1 Belt Kit assembly manual
P a g e
24 | 30
NOTE: You should bend the belt tabs on the bed plate in a flat shape, in order to avoid
interference with the belt, you can use some pliers to achieve this:
Figure 31 1020 Alu profiles must be centered with Heatbed base plate.Check for aligned holes pairs. Distance
between Alu bars must be 40 mm.
Installing heatbed Assembly:
Install heat bed element back again holding with Screws
and leveling nuts, compress the springs almost half their size.
Proceed to insert Heated bed with support alu bars assembled, from the right side of
machine right under the tensioned BELT. (cable of heatbed will come out from the
right side to the machine and going to the electronic box)