User Manual MIC 980
Issue 21.01.2019_01
21
7
Readiness mode
In this operating mode the temperature is controlled according to the pre-programmed nominal
temperature value. Air circulation is running with the pre-set air circulation level.
Be aware
In order to start readiness mode the pre-programmed nominal temperature has to be higher
than 0!!
Hint
The air circulation level has to be pre-programmed as 1 or 2, so that the heating can be
actuated during the night-time pre-heating interval
1
.
Be aware: Administrators
If administrators have been assigned in the controller, a password will be required before a
program can be started. Only administrators with the user right „Program start“ can start
readiness mode.
Program line
Selecting a start program
1. Direct program number entry
(see item 1.7)
2. Selecting a program from the list
Step line
Selecting a start program step
2
3. Direct step number entry
(see item 1.7)
Selecting a step from the list
(only
„valid“
steps are shown on the list, see item
4.2.3)
Temperature value
1. Currently measured temperature
2.
Nominal temperature for the control
process
(can be changed)
3. Symbol when burner is active
(Heating level 1)
Optional displays
3
Use buttons 1 and 2 to change the optional
display to your requirements.
For an explanation of the individual displays
see item 7.1
1. Previous display
2.
Next display
1
Configuration setting in the basic configuration: no heating without air circulation
(Code 5052, Alarm 2. Setting
can be changed)
2
It may be necessary to change steps in order to check the nominal step values.
3
Settings for the optional displays can be customised to your needs under Menu/Service/Optional displays.
1
2
3
1
2
1
2
1
2
3
