HE10.1 Assembly Instructions
2
HE10.1 Assembly Instructions
2
Copyright
2001-2004 Adire Audio
. All Rights Reserved. This design is for private, non-retail/non-
commercial use only. Any use of this design for profit, in any way shape or form, without the express
written consent of Adire Audio is strictly prohibited.
1. Introduction
Welcome to Adire Audio’s HE10.1 Mark II loudspeaker system. The HE10.1 Mark II is a high-
performance high efficiency coaxial driver system, designed for use where high efficiency is required, such
as PA monitors and use with low-power amplifiers (specifically SET amplifiers). It features a 10” paper
cone driver with a coaxially mounted compression driver loaded into a 90
°
conical constant directivity
horn, which yields an in-room system sensitivity of 95 dB SPL @ 2.83 Vrms. The Mark II model includes
an upgraded compression driver for even quicker decay and flatter response.
2. Parts
Your kit should include the following parts (quantities given are for a pair):
Part
Qty
Use
3.6 uF 250VDC polypropylene capacitor
4
C1011, C1031
12 uF 250VDC polypropylene capacitor
2
C2021
10 uF 250VDC polypropylene capacitor
2
C2041
6.2 uF 160VDC polypropylene capacitor
2
C2061
0.24 mH 20 GA perfect lay air core coil
2
L1021
0.62 mH 20 GA perfect lay air core coil
2
L2021
1.3 mH 16 GA perfect lay air core coil
4
L2031, L2051
2.4 Ohm 10W sandcast resistor
2
R1011
20 Ohm 10W sandcast resistor
2
R2021
12 ounce polyfill
2
Stuffing in the boxes
4”ID by 4.4”L vent
2
Vents
BETA 10CX 10” midrange/woofer
2
Woofers
ACD1 1” compression driver
2
Tweeters
SIC single input cup
2
Single pair input cup
14GA/2C 14GA twin conductor cable
10
Internal wiring
0.25” female FAST-ON connector
16
Terminal connectors
21cm long wire tie wrap
28
Crossover assembly
Large T-nut/socket cap screw set
16
Woofer mounting
If any parts are missing, please contact the factory as soon as possible, and we’ll correct the shortage.
3. Needed Tools
You’ll need to supply the following parts and tools to assemble the HE10.1:
-
Mounting board (hardboard, plywood, or any other material suitable for crossover mounting)
-
Electrical tape
-
Masking tape
-
Pliers
-
Razor blade or sandpaper
-
Wire cutters
-
Soldering iron
-
Solder
