ICONS:
Below are the application/system icon assignments:
FACTORY RESET:
The watch can be reset by either a hard reset or a soft reset. To perform a hard reset the
contact plates of the MCU’s reset pin is depressed. On the other hand, a software reset is
done by holding A) START, B) CONFIRM, and the C) MODE buttons for 5 seconds, during
which a beep shall be sounded off every second during the countdown until the 5 second
times out.
Upon watch reset, the watch shall execute the following sequence:
1. Turn all LCD Segments on.
2. Generate a 1 second beep to confirm the Piezo test.
3. Turn on lamp and all LCD Segments on.
4. Wait for 2 seconds.
5. Do not continue if all buttons are not released.
6. Turn off all LCD Segments.
7. Display the software code for 2 seconds.
8. Display the software major version for 2 seconds.
9. Display the software minor version for 2 seconds
10. Turn off lamp.
11. Do not continue if all buttons are not released.
12. Slowly rotate bezel counter-clockwise until message is cleared.
13. Proceed to the Time of Day application.
NOTE: you will need to re-enter your setup information: Reference (SETUP) in the instructions above.
