Industrial
Electronic Devices
ADFweb.com S.r.l.
User Manual
M-Bus Slave / Modbus Master - Converter
Document code: MN67059_ENG Revision 2.000 Page 27 of 33
UPDATE DEVICE (FOR HD67059M):
By pressing the “
Update Device
” button it is possible to load the created
Configuration into the device, and also the Firmware if is necessary, using the RS232
port.
In order to load the parameters or update the firmware in the device, follow these
instructions:
Turn OFF the Device;
Connect the RS232 cable from your PC to the Converter;
Insert the Boot Jumper;
Select the “
COM port
” and press the “
Connect
” button;
Turn ON the device;
Check the “Boot state” Led. It must blink quickly;
Select which operations you want to do.
Press the “
Execute update firmware
” button to start the upload;
When all the operations are “OK” turn OFF the device;
Remove the Boot Jumper;
Disconnect the USB/RS232 cable;
Turn ON the device.
At this point the configuration/firmware on the device is correctly updated.
Figure 5a: “Update Device” windows
