Industrial
Electronic Devices
ADFweb.com S.r.l.
User Manual
PROFINET/ HART Master
Document code: MN67912_ENG Revision 1.000 Page 16 of 30
SET COMMUNICATION:
This section define the fundamental communication parameters of HART and
Modbus buses.
By Pressing the “
Set Communication
” button from the main window for SW67912
(Fig. 2) the window “Set Communication” appears (Fig. 3).
The means of the fields for the “HART Master” section are:
In the field “
Address
” the type of Master is defined;
In the field “
Retry Limit
” the maximum number of retries in case of missing
response from HART device is defined;
The meaning of the fields of “PROFINET” are:
In the field “
IP ADDRESS
” the IP address to assign to the converter is
defined;
In the field “
SUBNET
Mask
” the SubNet Mask of the converter is defined;
In the field “
GATEWAY
” the default gateway of the network is defined. This
feature can be enabled or disabled pressing the Check Box field. This feature
is used for going out of the net;
In the field “
Tunneling
Port
” the port to use for the “Tunneling mode” is
defined (see page 28 for more details);
In the field "
Name of Station
" the name of PROFINET side of the converter
is defined;
In the field "
Number Bytes Input
" the number of byte from the PROFINET
Master to the converter is defined (it is possible to use up to 1439 byte);
In the field "
Number Bytes Output
" the number of byte from the
converter to the PROFINET Master is defined (it is possible to use up to 1439
byte);
If the field “
Diagnostic
” is checked, the diagnostic function is enabled. In
the field on the right, the starting PROFINET byte where saving the
diagnostic is defined (see page 24 for more details).
Figure 3: “Set Communication” window
