Industrial
Electronic Devices
ADFweb.com Srl – IT31010 – Mareno – Treviso INFO:
www.adfweb.com
Phone +39.0438.30.91.31
User Manual
DALI / Serial - Converter
Document code: MN67831_ENG Revision 1.100 Pagina 37 di 56
Where:
‘ch’ = ID of the DALI ballast read;
‘val’ = actual ADV set;
‘typ’ = type of DALI lamp;
‘rs’ = last response to DALI command;
‘min’ = minimum settable ADV;
‘max’ = maximum settable ADV;
‘g1’ = groups set inside the DALI device (from 0 to 7);
‘g2’ = groups set inside the DALI device (from 8 to 15);
‘scn’ = scenes programmed inside the DALI device (1 byte for each scene, total of 16 bytes).
Note:
Just ‘ch’, ‘val’, ‘typ’, ‘rs’, ‘min’, ‘max’, ‘g1’, ‘g2’ and ‘scn’ are variable, the rest of the ASCII string is fixed.
Note:
‘\r’ and ‘\n’ are respectively ‘carriage return’ and ‘line feed’.
Note:
For scenes not set, the value will be ‘FF’ (ASCII).
Note:
In order to address the Serial command to a specific converter in the serial line, it is necessary to add at the start of the commands
the chars “nnn.” where ‘nnn’ is the ID Board set in section “Set Communication” of SW67831. The response will contain the additional chars
too.
