Industrial
Electronic Devices
ADFweb.com Srl – IT31010 – Mareno – Treviso INFO:
www.adfweb.com
Phone +39.0438.30.91.31
User Manual
EtherNet/IP / M-Bus Master - Converter
Document code: MN67077_ENG Revision 1.100 Page 14 of 39
SET COMMUNICATION:
This section define the fundamental communication parameters of two buses, EtherNet/IP and M-
Bus.
By Pressing the “
Set Communication
” button from the main window for SW67077 (Fig. 2) the
window “Set Communication” appears (Fig. 3).
The window is divided in two sections, one for the EtherNet/IP and the other for the M-Bus.
The means of the fields for “EtherNet/IP ” are:
In the fields “
IP ADDRESS
” insert the IP address that you want to give to the Converter;
In the fields “
SubNet
Mask
” insert the SubNet Mask;
In the fields “
GATEWAY
” insert the default gateway that you want to use. This feature can be
enabled of disabled pressing the Check Box field;
In the field “
Port
” the port number used for EtherNet/IP communication is defined. It is fixed
to 44818;
In the field “
Number Byte Output
” insert the number of bytes that the Converter sends on
EtherNet/IP with the data of the Slaves M-Bus contained;
If “
Normal Mode
” is checked the 500 bytes of EtherNet/IP are used for storing the data of all
M-Bus slaves; otherwise if “
Single Slave Mode
” is checked, all 500 bytes are used for storing
the data of a single slave (see section “Single Slave Mode Functioning” at page 23 for more
details).
The means of the fields for M-Bus are:
In the field “
Baudrate
” it is possible to select the baudrate of the M-Bus line;
In the field “
Parity
” it is possible to select the parity of the line;
If the field “
Cyclic
Delay
” insert the time (expressed in seconds) between two scans;
In the field “
Node State value when slave device is not present
” it is possible to insert the
value to assign to the “Node State” when the Gateway doesn’t find the interrogated slave M-
Bus.
Figure 3: “Set Communication” window
