Industrial
Electronic Devices
ADFweb.com Srl – IT31010 – Mareno – Treviso INFO:
www.adfweb.com
Phone +39.0438.30.91.31
User Manual
RS232/S485/USB / Optic Fiber
Document code: MN67072_ENG Revision 1.001 Page 15 of 18
UPDATING FIRMWARE:
It is possible to update the Firmware of the device. For doing that, it is necessary to
download from this link,
www.adfweb.com/download/filefold/SW67072.zip
, the program,
install it and follow these instructions:
Turn off the Device;
Connect the RS232/RS485/USB cable (depending on the code of the device) form your
PC to the Gateway;
Put the Dip1 of Dip-Switch A at ON position (For more info see Figs. 1,2,3);
Select the COM port and press the “
Init
” button;
Turn on the device;
Check the Leds. All must blink quickly (For more info see Figs. 1,2,3);
Press the “
Update Firmware
” button;
Wait than the progress bar is full and appears “Progress: Update Done” and then turn
off the device;
Put the Dip1 of Dip-Switch A at OFF position;
Turn on the device.
At this point the firmware on the device is correctly updated.
Warning:
If the “Progress: Update Done” doesn’t appears when you try to do the Update
before require assistance try these points:
Check if the serial COM port selected is the correct one;
Check if the serial is connected between the PC and the device;
Try to repeat the operations for the updating;
If you are using a dongle try with a native COM port or change the dongle;
Try with another PC;
Try to restart the PC.
