MagnaClean
®
Micro
2
has been developed by the company that pioneered
magnetic filtration. ADEY’s filters protect more than three million central heating systems
in UK homes removing virtually 100% of the damaging suspended black iron oxide
sludge that builds up in all heating systems.
The dual-action filter can be installed anywhere on the main circuit. However, to achieve
the best level of protection for the boiler, it is recommended that MagnaClean Micro2 is
fitted after the last radiator and before the boiler.
Installation
Open vented system
Combi/Sealed system
Your system is protected by
Annual service required
www.adey.com
Lubricate
with jointing
compound
2
Servicing
3
2
1
4
2
Open drain
Close
drain
Open vent
Take care not to
over tighten
4
No need to
over tighten
7
6
7
CUT AND REMOVE SECTION
1
1
2
3
Tighten compression nuts
4
5
8
9
6
2
1
3
Open
vent
Turn
valves
ON
10
1
2
3
Open vent
Turn
valves
OFF
1
3
1
2
3
4
Clean
Clean
5
Clean
Remove sleeve
1
2
3
Open
vent
Turn
valves
ON
8
Ensure pin is in
locked position
Micro
Micro
98mm
The following instructions are designed to support
engineers in the safe and effective installation
and servicing of MagnaClean Micro2 and should
be followed at all times. Ensure the filling loop
is fitted after the filter. The lid seal should be
checked for wear when servicing MagnaClean. It is
best practice to replace the lid seal at each service.
To arrange replacements please visit adeyspares.
co.uk or contact the ADEY Team on 01242 546717.
In both diagrams, position A is
recommended as part of ADEY’s Best
Practice
™
approach. Position B is suitable
if space is tight on the return.
When completing a system flush using
MagnaCleanse
®
always ensure this is
installed and carried out on the return
pipe of the system for optimum boiler
protection.
Close
vent
Close
vent
Close
vent
Close
vent
