5
Heating Element Assembly
Body
5>. According to the request of use angle,
Heating Element Assembly can adjust
Angle at 0º~45º. (Fig.5)
WALL MOUNTED
1.Take out the black screw from control panel box,then fixed with the body with that black
screw tightly.
2.To mounting in the wall to use the 4 screws (package in sperate). Drill the holes on the wall,
insert the plastic expanded plugs and install each screws.
3.Raise the heater and assembly it on the holes on back of itself.
4.Move the heater smoothly on the right to catch steady.
OPERATION
The appliance is switched on by means of the pull switch (5). The slight vibration
noticeable when the appliance is switched on will stop after a few seconds.
OUTPUT
-Position 0: Stop
-Position 1: 650W (lower power)
-Position 2: 1300W (medium power)
-Position 3: 2000W (high power)
MAINTENANCE
Your appliance does not requires any particular maintenance. However, in the event of
a malfunction,
please consult an Approved Service Center
.
1
，
This appliance is not intended for use by persons (including children) with reduced
physical,sensory or mental capabilities.or lack of experience and knowledge,unless they
have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.
2
，
Children should be supervised to ensure that they do not play with the appliance.
