INSTALLATION GUIDE
SOL FUSION PLUS® SHOWER MIXER
SYSTEM REQUIREMENTS
Operating Pressures - refer to the Venturi Selection Table on page 2
Unequal Pressure - Venturi jet installed
Operating Pressures
Equal High (Mains) & Equal Low Pressures - Venturi jet removed
Operating Hot Water Temperatures
Operating Cold Water Temperatures
Do not plug outlet when testing.
This shower mixer can be line tested up to 1500kPa (217.6psi)
WHAT IS IN THE PACK
MINIMUM
MAXIMUM
20kPa (2.9psi)
36kPa (5.1psi)
300kPa (43.5psi)
1500kPa (217.6psi)
1500kPa (217.6psi)
55° C
60° C
5° C
N/A
Hot
Cold
Mixer Assembly
2.5mm Allen Key
8g x 32 Dome Head
Square Drive
Stainless Steel Screws
Grub Screw
Handle Cap
AS/NZS 3500.1 states that pressures above 500kPa can cause damage from water hammer, reduce the life of
appliances, taps & fittings, cause excessive noise in the system and recommend that a pressure limiting valve (PLV) be fitted.
3x Venturi Jets for Unequal Pressures:
36-75kPa
YELLOW
JET
76-130kPa
RED
JET
BEFORE INSTALLATION
MIXER ORIENTATION
Pipework MUST be purged before connecting to the mixer
This mixer is designed to be connected with the hot water
supply on the left only and the cold water supply on the
right only.
If at any point the cartridge nut is removed, please ensure
that both black lines marked on the cartridge and cartridge
nut are aligned when the mixer is in full cold position as
shown in figure 1.
HOT
INLET
ONLY
COLD
INLET
ONLY
( FULL COLD POSITION )
Figure 1.
OUTLET
Page 1
Patented New Zealand No. 605175
20-35kPa
GREEN
JET
Handle
Fac O-Ring
IMPORTANT:
Factory fitted
WITHOUT
Venturi Jet
