ADEO Services YT5309-04, Сборка, использование, руководство по обслуживанию

Страница: 32 / 44

EN
32
operating position, whilst using
the product.
5. Never use the product standing on
steps or a ladder. Do not work over
shoulder height.
6. Always ensure the safety guard
supplied is fitted before using
the product. Never attempt to
use an incomplete product or
one fitted with an unauthorised
modification.
7. Check the cutting device regularly
for damage, and if damaged repair
immediately.
8. Do not overload the product.
9. Check immediately if the product
starts to vibrate abnormally.
Excessive vibration can cause
injury.
10.Switch the product off when
the cutting device is blocked.
Disconnect it from power supply
and remove the blockage. Inspect
the cutting device for damage
before using the product again.
11.Follow the maintenance and repair
instructions for this product. Never
carry out any modifications of
the product. Information about
maintenance and repair is provided
in this instruction manual.
12.Know how to stop the product
quickly in an emergency.
13.Do not expose the product to rain.
Do not operate the product on a
wet hedge.
14.Use the product only in daylight or
good artificial light.
15.Prolonged use of the product
exposes the user to vibrations that
can cause a range of conditions
collectively known as hand-arm
vibration syndrome (HAVS) e.g.
fingers going white; as well as
specific diseases such as carpal
tunnel syndrome.
To reduce this risk when using the
product, always wear protective
gloves and keep your hands warm.
The symptoms of HAVS include
any combination of the following:
Tingling and numbness in the
fingers; Not being able to feel
things properly; Loss of strength
in the hands; Fingers going white
(blanching) and becoming red and
painful on recovery (particularly
in the cold and wet, and probably
only in the tips at first). Seek
medical advice immediately if such
symptoms are experienced.
Maintenance and storage
1. Disconnect the product from the
power supply (i.e. remove the plug
from the power supply ) and check
SAFETY INSTRUCTIONS