ADENDORFF MC900, Инструкция по эксплуатации

Страница: 14 / 18

vm.
Operation
Tool rest (Flgure 16)
1. The tool rest (1 J can be used with or
without the arm [2].
2. To move the tool rest base [3], loosen
the lock lever [4], and move the base to the
right or left and back or front. Tighten the
lever [4] when the tool rest base is in the
desired position.
3. When using the arm [2], make the necessary
adjustments using lock levers [5] and (6]
to
position the tool rest.
4. Tighten all tool rest lever handles [4-5-6] and
ensure there is adequate clearance between
the workpiece and the tool rest assembly
before turning the lathe on.
5. The tool rest can also be repositioned to the
extension bed for use on outboard turnings.
(Figure 17)
1
Fig. 16
Fig. 17
IMPORTANT:
MAKE SURE THE TOOL REST IS ADJUSTED TO BE AS
CLOSE TO THE WORKPIECE AS POSSIBLE. ROTATE THE WORKPIECE BY
HAND TO CHECK CLEARANCE BEFORE TURNING THE LATHE "ON".
IX • Maintenance
WARNING:
FOR YOUR OWN SAFETY, TURN THE SWITCH "OFP AND
REMOVE THE PLUG FROM THE ELECTRICAL OVTl..ET BEFORE
PERFORMING MAINTENANCE OR LUBRICATION WORK ON THE LATHE.
1. Blow out dust accumulation inside the motor, housing, and bed assembly frequently.
2. A
coat of automotive wax applied to the bed will help keep the surface clean and the
movement of the tool rest and tailstock smooth.
3. Pertodic lubrication of the spring levers and other threaded parts will make these parts
easier
to operate.
L-----------
1
14\------------�